Thursday, September 11, 2014

Lasercut case- dry fit

I collected the test cut of the case last night, and checked it against the components: This video only shows the Raspberry Pi in the case at the moment because there are a couple of adjustments I need to make- slight dimensional inaccuracies because I measured everything with a ruler instead of a vernier caliper, and ratoinalisation of cuts- removing material I don't need and adding in one or two places where things are a little weak. I'll upload a CC-licensed verison of this in keeping with the source license of the pibow I started from. Adjustments will be made to the DWG file and I should have a final fit cut in white oak next week.

No comments:

Post a Comment